21 lines
1.1 KiB
Markdown
21 lines
1.1 KiB
Markdown
V2 Power Skirt
|
|
============================
|
|
|
|
A skirt piece to replace the lefthand (empty) or righthand fan holder with this.
|
|
I bought the screen here: https://nl.aliexpress.com/item/4001268132948.html?spm=a2g0s.9042311.0.0.48094c4dXCEnMz
|
|
I chose the one with the torus because that's the easiest to install one.
|
|
|
|
Steps to install:
|
|
1) Disconnect printer from mains
|
|
2) Connect the screen's wires (L-N and CT). You can also plug in the provided temperature sensor already, just be careful when inserting the screen into the skirt.
|
|
3) Slide the screen into it, it should be press fit, maybe a bit on the loose side.
|
|
4) Slide the torus over the mains input, before you split it off to power the PSUs/Bed. This way you measure the entire printer, not just one branch of the split.
|
|
5) If you didn't do the temperature sensor at 2, now's your moment to do it. I tiewrapped mine to a wire so it measures the electronics compartment.
|
|
6) Remove the M5 T-nut from the rail and insert two M3 T-nuts to hold the skirtpiece.
|
|
7) Fasten with 2 M3*8.
|
|
8) Power up.
|
|
|
|
|
|
|
|
|