A Clippable V0 LED Caselight (#307)

* joposter: add v0 clippable led mount

add CAD
add STLs
wrote readme

* joposter: add clippable led mount to global printer_mods readme

* v0_clippable_ledmount: remove combined plate stl

* v0_clippable_ledmount: add small note about self-glueing led adhesive

Co-authored-by: Julian Daube <joposter@gmail.com>

printer_mods/README.md

@@ -111,6 +111,7 @@ like so:
 | | [Mid Panel](./JNP/Mid-Panel)| Panel for SKR1.4/1.4 or SKR E3 mini mount | :heavy_check_mark: |:x: |:x: |:x: |
 | | [Neopixel Case](./JNP/Neopixel-Y_Rails) | mounting for Neopixel strip with 8 LED´s | :heavy_check_mark: |:x: |:x: |:x: |
 | | [Side Panels](./JNP/Side-Panels) | Panels with intergrated hinge | :heavy_check_mark: |:x: |:x: |:x: |
+| joposter | [V0 Clippable LED Caselight](./joposter/v0_clippable_ledmounts) | LED Case light for the V0 that clips into the extrusions | :heavy_check_mark: | :x: | :x: | :x: | :x: |
 | KenadyDwag44 | [Switchwire Lightbar](./KenadyDwag44/sw_lightbar) | A LED lightbar for switchwire | :x: | :x: | :x: | :heavy_check_mark: |
 | KiloQubit | [V0 Reverse Bowden Mount](./KiloQubit/V0_reverse_bowden_mount)| V0 reverse bowden mount | :heavy_check_mark: | :x: | :x: |:x:|
 | | [V2.4 Z Chain Mounts for 3 Hole Chains](./KiloQubit/VORON_2.4_Z_Chain_3_Hole_Mounts)| Z chain mounts for 3 hole generic chain | :x: | :x: | :heavy_check_mark: |:x:|

printer_mods/joposter/v0_clippable_ledmounts/README.md

@@ -0,0 +1,21 @@
+# V0 clippable Caselight LED Mounts
+
+![](images/printer_installed.jpg)
+
+This LED strip mount is sutable for led strips with a width of 8 - 12 mm, but was made 
+for [these](https://www.ebay.de/itm/114381606552) 24V COB Led strips. 
+![](images/cob_led.jpg)
+
+Since they come in segments of 62.5 mm, the strip mounts are 125mm long to fit two of those segments. 
+When using different leds, the slicer scaling function can be used to shorten them. The clips should still work. 
+
+## Attach the LEDs
+
+The mentioned led strips come with an M3 adhesive pre-applied, which should be the case for most LED strips commonly found online. This adhesive should be sufficient for attaching LEDs to this mount. 
+
+
+## How to print them 
+
+The clips were made to print upright, but will probably require a brim for bed adhesion. 
+
+![print orientation](images/slicer_brim.jpg)