53 lines
1.2 KiB
INI
53 lines
1.2 KiB
INI
#This file contains common pin mappings for the BigTreeTech SKR 2.
|
|
# To use this config, the firmware should be compiled for the
|
|
# STM32F407 with a "32KiB bootloader".
|
|
|
|
# The "make flash" command does not work on the SKR 2. Instead,
|
|
# after running "make", copy the generated "out/klipper.bin" file to a
|
|
# file named "firmware.bin" on an SD card and then restart the SKR 2
|
|
# with that SD card.
|
|
|
|
# See docs/Config_Reference.md for a description of parameters.
|
|
|
|
[board_pins]
|
|
aliases:
|
|
# BLTouch (Servo/Probe)
|
|
SERVO0=PA1,
|
|
PROBE=PC14,
|
|
|
|
# Power Controls
|
|
PS_ON=PC13,
|
|
PWE_DCT=PC12,
|
|
|
|
# RGB
|
|
RGB=PA8,
|
|
|
|
# Limit Switches
|
|
X_STOP=PC0,
|
|
Y_STOP=PC1,
|
|
Z_STOP=PC2,
|
|
E0_STOP=PC15,
|
|
|
|
# Steppers
|
|
RX=PC11, TX=PC10,
|
|
X_STEP=PB13, X_DIR=PB12, X_ENABLE=PB14,
|
|
Y_STEP=PB10, Y_DIR=PB2, Y_ENABLE=PB11,
|
|
Z_STEP=PB0, Z_DIR=PC5, Z_ENABLE=PB1,
|
|
E0_STEP=PB3, E0_DIR=PB4, E0_ENABLE=PD1,
|
|
|
|
TEMP_0=PA0,
|
|
TEMP_BED=PC4,
|
|
|
|
FAN=PC6,
|
|
FAN1=PC7,
|
|
FAN2=PB15,
|
|
HEAT_0=PC8,
|
|
HEAT_BED=PC9,
|
|
|
|
# EXP1 header
|
|
EXP1_1=PB5, EXP1_3=PA9, EXP1_5=PA10, EXP1_7=PB8, EXP1_9=<GND>,
|
|
EXP1_2=PA15, EXP1_4=<RST>, EXP1_6=PB9, EXP1_8=PD6, EXP1_10=<5V>,
|
|
|
|
# I/O Header
|
|
IO_1=PD5, IO_2=PD4, IO_3=PD3, IO_4=PD2,IO_5=PD0
|