diff --git a/pinouts.d/btt-skr-mini-e3-v3.0.cfg b/pinouts.d/btt-skr-mini-e3-v3.0.cfg
new file mode 100644
index 0000000..536a165
--- /dev/null
+++ b/pinouts.d/btt-skr-mini-e3-v3.0.cfg
@@ -0,0 +1,49 @@
+#This file contains common pin mappings for the BigTreeTech SKR 2.
+# To use this config, the firmware should be compiled for the
+# STM32F407 with a "32KiB bootloader".
+
+# The "make flash" command does not work on the SKR 2. Instead,
+# after running "make", copy the generated "out/klipper.bin" file to a
+# file named "firmware.bin" on an SD card and then restart the SKR 2
+# with that SD card.
+
+# See docs/Config_Reference.md for a description of parameters.
+
+[board_pins]
+aliases:
+    # BLTouch (Servo/Probe)
+    SERVO0=PA1,
+    PROBE=PC14,
+   
+    # Power Controls
+    PS_ON=PC13,
+    PWE_DCT=PC12,
+
+    # RGB
+    RGB=PA8,
+
+    # Limit Switches
+     X_STOP=PC0,
+     Y_STOP=PC1,
+     Z_STOP=PC2,
+    E0_STOP=PC15,
+
+    # Steppers
+    RX=PC11, TX=PC10,
+     X_STEP=PB13, X_DIR=PB12,  X_ENABLE=PB14,
+     Y_STEP=PB10, Y_DIR=PB2,   Y_ENABLE=PB11,
+     Z_STEP=PB0,  Z_DIR=PC5,   Z_ENABLE=PB1,
+    E0_STEP=PB3, E0_DIR=PB4,  E0_ENABLE=PD1,
+
+    TEMP_0=PA0,
+    TEMP_BED=PC4,
+
+    FAN=PC6,
+    FAN1=PC7,
+    FAN2=PB15
+    HEAT_0=PC8,
+    HEAT_BED=PC9,
+
+    # EXP1 header
+    EXP1_1=PB5,  EXP1_3=PA9,   EXP1_5=PA10, EXP1_7=PB8,  EXP1_9=<GND>,
+    EXP1_2=PA15, EXP1_4=<RST>, EXP1_6=PB9,  EXP1_8=PD6, EXP1_10=<5V>