VoronUsers/printer_mods/nikolasbabetas/Neopixel_Holder

Neopixel Mount

These are neopixel mounts that slide into the V0.1's top extrusions (20 leds in total)

BOM

• Neopixel/WS2812B led strip (60 leds/m) only 34cm, 20 leds are needed
• Cables

Instructions

• Print 4 of the "Neopixel_Mount" (2 for each side)
• Solder only the 5V and GND wires on the led strips
• Slide them into the mounts
• Solder the signal wire based on the diagram below (There is a hole in the mount to allow the wire to go from the one strip to the other)
• Remove the 2 screws holding each extrusion into place
• Remove the 3 screws that attach the panels onto each extrusion
• Slide the mounts onto each extrusion and screw the extrusions in place

Neopixel Holder

Printed Parts

Circuit Diagram

Assembly