Add mod for V0 skirts with zip tie mounting points (#246)

printer_mods/README.md

@@ -36,6 +36,7 @@ like so:
 |arkeet|[Dial test indicator mount](./arkeet/dti-mount)|A toolhead mount for a dial test indicator, where the tip is located at the nozzle. |:x:|:heavy_check_mark:|:heavy_check_mark:|:x:|
 | |[Magnetic hotend fan cover](./arkeet/magnet-fan-cover)|A replacement hotend fan cover, held with magnets instead of screws. |:x:|:heavy_check_mark:|:heavy_check_mark:|:heavy_check_mark:|
 |claytono|[Voron 2.4 Extrusion Jig](./claytono/2.4-extrusion-jig)|A jig help align extrusions to get a properly square frame |:x:|:x:|:heavy_check_mark:|:x:|
+||[V0 Zip Tie Skirts](./claytono/v0-zip-tie-skirts)|V0 skirts with small loops added along the top to allow zip tyiing cables to them|:heavy_check_mark:|:x:|:x:|:x:
 |Badnoob |[Precision AB Drive](./Badnoob/Precision_AB_Drive)|Changes the gearing for the AB drives to improve both resolution and torque, with a strenthened frame. |:grey_question:|:grey_question:|:heavy_check_mark:|:x:|
 | |[Rail Alignment](./Badnoob/Rail_Alignment)|Tools and procedure to properly align the rails in 2.4 and Afterburner|:x:|:x:|:heavy_check_mark:|:x:|
 | BladeScraper-Designs | [Microswitch_Pod_With_Connector](./BladeScraper-Designs/Microswitch_Pod_With_Conector) | Microswitch pod with JST-XH 4-pin connector | :x: |:x: |:heavy_check_mark: | :x:

printer_mods/claytono/v0-zip-tie-skirts/README.md

@@ -0,0 +1,8 @@
+# V0 Skirts with integrated zip-tie points
+
+![Skirt Render](V0_Zip_Tie_Skirts.png)
+
+This is a pretty simple mod that adds a series of small loops along the top of
+the V0 skirts that you can use to zip tie cables to.
+
+These skirts also have an access hole added for tightening the middle M3 screw.