Redesigned V0 Thumb Nuts (#827)

* Add redesigned thumb nuts

* Update readme

* Rename file to voron standard

* Address review notes

printer_mods/README.md

@@ -55,6 +55,7 @@ like so:
 | |[Mini Afterburner ADXL345 Mount](./Andre/Mini_Afterburner_ADXL345_Mount)|Mount for an AXDL345 on the Mini Afterburner|:heavy_check_mark:|:x:|:x:|:x:|
 | |[Revo Nozzle Skirt](./Andre/Revo_Nozzle_Skirt_Trident)|A Revo nozzle box hidden in a Trident skirt.|:x:|:x:|:x:|:x:|:x:|:heavy_check_mark:|
 |antoinecellerier|[DS18B20 Sensor Mount](./antoinecellerier/ds18b20-sensor-mount)|DS18B20 temperature sensor mount|:heavy_check_mark:|:x:|:x:|:x:|:x:|
+| ardichoke | [V0 Long Thumb Nut](./ardichoke/v0-long-thumb-nut) | Taller thumb nuts for V0 bed | :heavy_check_mark: | :x: | :x: | :x: | :x: |
 |arkeet|[Dial test indicator mount](./arkeet/dti-mount)|A toolhead mount for a dial test indicator, where the tip is located at the nozzle. |:x:|:heavy_check_mark:|:heavy_check_mark:|:x:|
 | |[Magnetic hotend fan cover](./arkeet/magnet-fan-cover)|A replacement hotend fan cover, held with magnets instead of screws. |:x:|:heavy_check_mark:|:heavy_check_mark:|:heavy_check_mark:|
 | |[MGN12 X-axis](./arkeet/mgn12/)|Replaces the dual MGN9H rails with a single MGN12H. |:x:|:x:|:heavy_check_mark:|:x:|

printer_mods/ardichoke/v0-long-thumb-nut/README.md

@@ -0,0 +1,15 @@
+# Longer Thumb Nuts for Voron V0
+
+After installing a Kirigami mount for my V0 bed, I found that the stock thumb nuts were
+too short, which made them very hard to adjust. I have also never been particularly fond
+of the shape of them and found them uncomfortable to adjust.
+
+![Finished part](images/part.jpg)
+![Bed with installed part](images/installed.jpg)
+
+## Usage
+
+1. Print it, the standard Voron settings worked fine for me.
+1. Install 3mm heat set inserts to the bottom of the thumb nut (so that the tension will pull the heat set insert into the part, not out of it)
+1. Replace your stock thumb nuts
+1. Redo your bed leveling