Add V0 Neopixel Front Bed Mount (#327)

* Add V0 Neopixel Front Bed Mount

* clarify installation re: friction fit

printer_mods/Andre/V0_Neopixel_Front_Bed_Mount/README.md

@@ -0,0 +1,28 @@
+V0 Neopixel Front Bed Mount
+===========================
+
+This replaces the stock V0.1 Front Bed Mount, adding a slot for a single Neopixel or Dotstar LED from a standard 10mm strip.
+There are channels to run the wires stealthily to inside of the bed frame extrusions on either side.
+
+Instructions
+------------
+
+- Print `Diffuser_x1` with 100% infill using a transparent or white ABS, textured build surface is a bonus.
+- Print `Front_Bed_Mount_x1` using standard Voron print settings
+- cut a single Neopixel or Dotstar LED from a 10mm strip, and 3 (or 4 for Dotstar) equal lengths of wire, 
+  long enough to reach from the front bed mount, under the bed, through the cable chain and all the way to your mainboard.
+
+- insert the LED into the slot on the front of the bed mount, and route the wires through one or both of the channels
+- insert the diffuser in the slot in front of the LED, ensure a good friction fit.  if necessary, print the diffuser slightly thicker or thinner by scaling it in your slicer.
+- Install the new Bed mount, making sure the wires are not pinched by the extrusions, they should run directly into the slot, you can use zip ties to secure it.  
+- route the wires through the cable chain, and around to wherever your mainboard is mounted.
+- mainboard connections and klipper configuration are left as an exercise to the reader.
+
+
+Images
+------
+
+![CAD](Images/CAD_1.png)
+![CAD](Images/CAD_2.png)
+![PIC](Images/PIC_1.jpg)
+![PIC](Images/PIC_2.jpg)

printer_mods/README.md

@@ -40,6 +40,7 @@ like so:
 | |[Filament Runout Sensor](./al3ph/filament_runout)|A simple filament runout sensor |:heavy_check_mark:|:heavy_check_mark:|:heavy_check_mark:|:heavy_check_mark:|
 | |[PL05 Sensor Mount](./al3ph/pl05_mount)|A mount PL05 inductive sensor |:heavy_check_mark:|:x:|:x:|:x:|
 |Andre|[Mini Afterburner Strain Relief](./Andre/Mini_Afterburner_Strain_Relief)|A replacement strain relief for the Mini Afterburner toolhead|:heavy_check_mark:|:x:|:x:|:x:|
+| |[V0 Neopixel Front Bed Mount](./Andre/V0_Neopixel_Front_Bed_Mount)|A replacement Front Bed Mount with room for a neopixel or dotstar behind the logo|:heavy_check_mark:|:x:|:x:|:x:|
 |arkeet|[Dial test indicator mount](./arkeet/dti-mount)|A toolhead mount for a dial test indicator, where the tip is located at the nozzle. |:x:|:heavy_check_mark:|:heavy_check_mark:|:x:|
 | |[Magnetic hotend fan cover](./arkeet/magnet-fan-cover)|A replacement hotend fan cover, held with magnets instead of screws. |:x:|:heavy_check_mark:|:heavy_check_mark:|:heavy_check_mark:|
 | |[MGN12 X-axis](./arkeet/mgn12/)|Replaces the dual MGN9H rails with a single MGN12H. |:x:|:x:|:heavy_check_mark:|:x:|