V2 PowerSkirt (#213)

printer_mods/README.md

@@ -90,6 +90,7 @@ like so:
 | kirby | [V0 Sherpa Mini Direct Drive Mod](./kirby/v0_sherpa_mini_direct_drive)| A direct drive mod for the V0 using the Annex Sherpa Mini extruder | :heavy_check_mark: | :x: | :x: |:x:|
 |Kruppes |[V0 Printed Deck with inserts](./Kruppes/Deck_Panel_inserts_logo) |Electronics Deck Panel using brass heat inserts. Optional with accent color Voron Logo. |:heavy_check_mark: |:x: |:x: |:x:|
 | |[Encosed Bottom](./Kruppes/Closed_Bottom) | Modified printed parts and panel to fully enclose V0. |:heavy_check_mark: |:x: |:x: |:x:|
+|leandromarceddu|[PowerSkirt](./leandromarceddu/PowerSkirt) |Modified skirtpiece for a digital power monitor|:x:|:grey_question:|:heavy_check_mark:|:grey_question:|
 |littleferris |[V0 c14 Skirt Inlet](./littleferris/V0_Skirt_Inlet) |V0 C14 Skirt inlet |:heavy_check_mark: |:x: |:x: |:x:|
 |madros |[V0 OLED-skirt](./madros/V0_skirt_OLED) |V0 skirt with 0.96" OLED|:heavy_check_mark: |:x: |:x: |:x:|
 |MarcPot |[UHP PSU Bracket Clip](./MarcPot/UHP_PSU_Bracket_Clip)|DIN rail mount for the Mean Well UHP series PSU. |:grey_question: |:grey_question: |:heavy_check_mark: |:x:|

printer_mods/leandromarceddu/PowerSkirt/README.md

@@ -0,0 +1,20 @@
+V2 Power Skirt
+============================
+
+A skirt piece to replace the lefthand (empty) or righthand fan holder with this. 
+I bought the screen here: https://nl.aliexpress.com/item/4001268132948.html?spm=a2g0s.9042311.0.0.48094c4dXCEnMz
+I chose the one with the torus because that's the easiest to install one.
+
+Steps to install:
+1) Disconnect printer from mains
+2) Connect the screen's wires (L-N and CT). You can also plug in the provided temperature sensor already, just be careful when inserting the screen into the skirt.
+3) Slide the screen into it, it should be press fit, maybe a bit on the loose side.
+4) Slide the torus over the mains input, before you split it off to power the PSUs/Bed. This way you measure the entire printer, not just one branch of the split.
+5) If you didn't do the temperature sensor at 2, now's your moment to do it. I tiewrapped mine to a wire so it measures the electronics compartment. 
+6) Remove the M5 T-nut from the rail and insert two M3 T-nuts to hold the skirtpiece. 
+7) Fasten with 2 M3*8.
+8) Power up.
+
+![PowerSkirt](img/PowerSkirt.jpg)
+
+